Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document. © 2020 Norgren Automation Solutions, LLC Page 09 08/20
User In ructions for
PGS10 and PGS11 Grippers
b) Verify calibration:
(1) Close the gripper with no material between the pads. The LED(s) should be off.
(2) Close the gripper on a single blank of material. The Red LED(s) corresponding to you
material range should be on.
1. If an In-Pad Sensor is to be installed, it goes on top of the side plate assembly. Wrap
sensor cable through holder and align holes on side plate. Clean and apply Red Loctite 262
or equivalent to 2X M5 X 10mm SHCS and thread thru sensor into side plate. Tighten both
SHCS to 36in-lb.
2. Shim is only used for part numbers listed. If a shim is to be used on an angle pad, smaller
tabs go on the narrow side of the pads.
Small Tabs PGS10RXXXXX1XXX
PGS10FXXXXX1XXX
PGS10CXXXXX1XXX
PGS10DXXXXX4XXX
PGS10EXXXXX7XXX
PGS10SXXXXX1XXX
PGS10TXXXXX4XXX
PGS10UXXXXX7XXX
PGS10VXXXXX1XXX
PGS10WXXXXX4XXX
PGS10YXXXXX7XXX
H. Calibrating In-Direct
Sensor (cont.)
I. Installing an In-Pad Sensor
