Issue link: https://onenorgren.uberflip.com/i/555071
2 VALVES VAL-316 For further information www.norgren.com Manifold Mount Base Valves KIP Series standard manifold mount base valves offer a cost effective method of secu- ring valves to manifolds, eliminating custom cavities or seat installations. Testing is simpli- fied and manifold design and "O" Ring sealing provides quick installation, interchangea- bility, service and replacement, without removing a single supply line or fitting. KIP Series manifold mount style valves are available in all Series from the Series 9 for low watt applications, to the Series 6 for high flow and high pressure requirements. Our complete line of manifold mount type valves allows you to mix and match different style valves on one manifold assembly to accommodate your application requirements. Male Bottom Port This option is available in Series 1, 2, & 3 with 1/8" NPT or 1/4" NPT male bottom port. The brass hex body has 1/8" NPT side ports for both the 1/8" and 1/4" models. Valves are available with a maximum orifice size of 1/8". When ordering a valve as a 2-way normally closed version, please indicate whether the male port is to be the inlet or outlet. The standard version has the side port as the inlet for both 2-way and 3-way valves. This option is ideal as a 3-way operator for piloting a cylinder. Installation is fast and easy. Units also can be ordered with male thread PTFE tape to save you additional time. Available with any electrical termination or housing style. Bottom Port- "O" Ring Seal IMI Norgren offers an option on Series 1, 2, 3, and 6 for bottom ported valves with an "O" Ring seal. This option utilizes one or two ports on the bottom of the valve body to have a counterbore pocket for a face sealing "O" Ring. The manifold surface is simply machined flat with matching hole locations and through holes matching up with the mounting holes of the valves. When a valve is installed with the mounting screws the "O" Ring provides a seal between the bottom of the valve body and the manifold surface. This feature is ideal for acrylic or other plastic manifolds where there is concern for thread life or cracking of the block by over torquing. Available in 2-way and 3-way valves. When only one bottom port is used, the remaining valve porting can be any of the options available in each series. Installation is quick and secure; trouble shooting or valve replacement can be accommodated with minimum effort. Non standard item - consult factory. Manifolds