Issue link: https://onenorgren.uberflip.com/i/555071
VALVES 2 VAL-277 For further information www.norgren.com Direct Porting Solenoid Valves Valves are available with a broad variety of materials of construction, port sizes, seal selections, termination styles, mounting brackets, pressure and flow capabilities to meet your most stringent application requirements. Our standard valves dimensionally meet the industry standards from mounting holes and ports, to valve sizes and configurations. IMI Norgren offers a wide selection of coil construction and meets virtually any voltage requirements. IMI Norgren is eager to install your fittings, attach your specific terminations to the lead wire or accommodate your unique mounting or installation requirements. Standard Valve Selection IMI Norgren has been developing and producing solenoid valves for over thirty years. In addition to our standard offering of solenoid valves, we can solve your fluid control problems with custom-made solutions. Our standard solenoid valve offerings are designed to meet the broad range of sectors that we serve from commercial vehicle, food and beverage, energy, life science, rail to industrial automation. Our complete line of 2 way and 3 way solenoid valves range provide a wide range of maximum operating differential pressures and flow rates that can satisfy today's most rigid requirements. These valves are ideally suited to remotely control systems that use air, liquids or vacuum. IMI Norgren Isolation Valves KIP Series 1, 2, 6 and 9 valves can be supplied as a diaphragm seal isolated valve. The diaphragm seal provides a dry isolated barrier for all the metal parts of the solenoid valve, maintaining only the seal and valve body (usually plastic), as the only wetted parts. The diaphragm isolated valve models are available as a 2-way normally closed valve only. However, if your application requires a 3-way, we can adapt two valves on a manifold block to act as a 3-way. Q2 The IMI Norgren Q2 quick connect valves are constructed with the durable lightweight plastic bodies with minimum pressure drop. The valves are UL and CSA rated along with the NSF certification for your potable water requirements. The standard Q2 valves are yoke style housing with a 10 watt coil with ΒΌ" top spades electrical connections. The Q2 solenoid valves have MOPDs of up to 120 PSI and orifice diameters from 1/8" to 5/16" giving you Cv factors up to 1.00. Series 9 The low watt Series 9 is the small solution without sacrificing performance. The valves are available in 2-way and 3-way configurations. The Series 9 is compatible with air, wa- ter, gases, and vacuum. The standard Series 9 orifice is 1/16" with a maximum MOPD of 100 PSI leading to a maximum Cv factor of .05. KIP Valve Products