E. Setting Jaw Open Angle
Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document. © 2020 Norgren Automation Solutions, LLC Page 06 08/20
User In ructions for
PGS10 and PGS11 Grippers
1. Look for bumper which should be on the upper jaw side. Remove M5X12mm SHCS from
side plate. If indirect sensor is in place of side plate remove M5X30mm from indirect
sensor. Rotate side plate/sensor up to about a 45° and remove from gripper. Set SHCS
and Side Plate/Sensor aside for re-assembly. Remove bumper from gripper.
2. Insert bumper into new position, based on required open jaw angle. Bumpers should only
be on the top jaw side of gripper. Jaws do not need to be removed to change bumper
position. Insert bumper into frame and insure bumper is seated properly.
22° Open
Jaw Angle
45° Open
Jaw Angle
70° Open
Jaw Angle
1. With the Side Plate at 45°, align pins of side plate with slots of frame. Slide pins into slot.
When pins are fully seated, rotate side plate and slide down onto frame.
F. Installing a Side Plate or
Indirect Sensor
