C. Jaw Removal
Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document. © 2020 Norgren Automation Solutions, LLC Page 04 08/20
User In ructions for
PGS10 and PGS11 Grippers
1. Release jaw by using a hex key or flat screwdriver and pushing on drive pin through slot in
side plate
1. Unlock gripper as shown in Step B and remove pad(s) from existing jaws. Set aside for
re-assembly.
2. Top jaw should always be removed first. Remove SHCS from side plate or indirect sensor.
Rotate side plate/sensor up to about 45° and remove side plate/sensor from gripper. Set
SHCS and Side Plate/Sensor aside for re-assembly. Remove bumper from gripper.
3. Remove jaw from gripper and flip gripper over to remove other jaw
4. Remove SHCS from side plate/sensor. Rotate side plate/sensor up to about 45° angle and
remove from gripper. Set SHCS and Side Plate/Sensor aside for re-assembly.
B. Gripper Unlock
