24
R
E
C
E
I
V
E
R
S
A
N
D
A
DA
P
T
E
R
S
5
For more information or for additional configurations,
please contact us at NASInsideSales@imi-precision.com
RAIL RECEIVER WITH REAR EXIT
AIR AND/OR ELECTRIC
LRR2XXXXXXXX
» Receiver bolts to transfer feedbar
» Acts as a docking device for quick changeover of transfer fingers
» Steel locating pins of receiver adapter slide into sleeved holes
of receiver face for maximum rotational stability
» Finger held in receiver by simple one touch spring loaded latch – no locking handle required
Order information
LRR2XXXXXXXX
Mount Type
Code
Long Keyplate A
Mount Plate Short B
Mounting Plate E
Short Keyplate K
No Keyplate N
Electric Connector Type
and Location
Code
No Connector NN
3-Pin Backplate Mount 3B
4-Pin Backplate Mount 4B
5-Pin Backplate Mount 5B
Pneumatic Ports and Location
- Note 1
Code
No Pneumatic Ports NN
Rear Exit Pneumatic 2 Ports (1/4-18) RY
Side Exit Pneumatic 2 Ports (1/4-18) SY
Rear Exit Pneumatic 2 Port (1/4-19) BY
Rear Exit Pneumatic 4 Port (1/4-18) C4
Under Exit Pneumatic 2 Ports (1/4-18) UY
Tooling Coding
Code
No coding N
Clear Mechanical Coding - Note 2 M
Red Mechanical Coding - Note 2 R
Mechanical Coding - Note 2 C
Finger Release Handle Type
Code
Mushroom Type 0
"T" Type 5
Electric Connector
Exit Orientation - Note 1
Code
No Connector N
Rear Exit Connector R
RH Side Exit Connector S
LH Side Exit Connector L
Under Exit Connector U
Note 1: The exit location of the electrical connector and pneumatic ports must be the same.
They must both exit the rear, the side, or the bottom.
Note 2: Mechanical Coding block is installed. The actual code is not configured at the factory.
Dimensions in inches (mm) are for reference only
