123
D
O
U
B
L
E
B
L
A
N
K
A
N
A
LY
Z
E
R
8
For more information or for additional configurations,
please contact us at NASInsideSales@imi-precision.com
Dimensions are for reference only
66.0464 shown
DSM3612 shown
DBA SYSTEM ACCESSORIES
66.0464
Bumper assembly for
36mm sensor
66.0020
Bumper assembly for
42 mm sensor
66.0019
Bumper assembly for
54 mm sensor
66.0199
Bumper assembly for
75 mm sensor
DSM3612
Vacuum cup for
36mm sensor
DSM3613
Vacuum cup for
42mm sensor
DSM3614
Vacuum cup for
54 mm sensor
» Threads on sensor to prevent blank surface marring
See cautions listed below.
Sensor Bumpers
» Thread on sensor to hold blank firmly against face of sensor
» Cup can protect blank from surface marring
See cautions listed below
Sensor Mounted Vacuum Cups
CAUTION:
Contact type sensors must come in contact with the blank to take a measurement. Air gaps up to .003 inch are acceptable, if this gap stays
consistent from measurement cycle to measurement cycle. Sensor bumpers and vacuum cups can interfere with the sensor face contact with
the blank. Failure to install and adjust properly can result in double sheets not being detected.
Note: The maximum single blank thickness rating of the DBA sensor must be lowered to 85% of its normal rating if bumpers or vacuum cups are mounted on the sensor.
66.0020 shown
DSM3613 shown
42.7045
Jam nut for 36mm sensor
42.7025
Jam nut for 42mm sensor
42.7016
Jam nut for 54mm sensor
42.7044
Jam nut for 75mm sensor
» Used to secure sensors in fixed positions
Sensor Jam Nuts
42.7025 shown
