Issue link: https://onenorgren.uberflip.com/i/555860
1 ACTUATORS ACT-58 For further information www.norgren.com 3/4" and 1-1/8" bore Single and double rod end styles FPM seals optional for higher temperatures Technical features Medium: Compressed air, filtered, lubricated or non-lubricated Operation: Single or double acting Operating Pressure: 150 PSI (10 bar) Operating Temperature: -20° to 200°F (-29° to 107°C) Cylinder Diameters: 3/4", 1-1/8" Differences between Series T and Series VT air actuators Series T contains a Quad Ring Nitrile piston seal. The VT Series utilizes a dual Block-Vee nitrile piston seal design. The Block-Vee seals increase the envelope dimensions of the Series VT cylinders by 3/8". All other features of the Series T and VT are the same. Series VT cylinders have a slightly lower breakaway pressure (psig) than the Series T Tiny Tim air cylinders. Options selector for T, VT, and ET Options Substitute Stroke adjustment single piston (specify adjustment length) A(–) Stroke adjustment double piston (specify adjustment length) AA(–) Cap end cushion C * Non-standard port location (Specify location) L(–) Non thread rod PR **Magnetic Piston PS Rod end cushion R Both ends cushioned RC Rod extension over standard. (Specify length) RX(–) Stainless steel tie rods and nuts S Spring on cap end (spring extends rod) SC Spring on rod end (spring retracts rod) SR Chrome-plated stainless steel piston rod SS Rod thread extension over standard (specify length) TX(–) Stainless Steel Tube TS FPM seals -20° to 400°F temperature range. V * Designate head position first, and cap position last ** PS option adds 1/2" to overall cylinder length Single Rod End Models Substitute Quad ring piston seal, block – vee rod seal T Block-vee piston and rod seals VT Ecology piston seals and block-vee rod seal ET Double Rod End Models Quad ring piston, block – v-rod seal DT Block-vee piston and rod seals VDT Ecology piston seals and block-vee rod seal EDT Mounting Styles Substitute Flush mount F Clevis mount C Nose mount SR Rear flange mount FC Front flange mount FR No mount NM Rod Diameter Specify 5/16" or 3/8" Bore Specify 3/4" or 1-1/8" Stroke (inches) Notes: Cylinder requires a stop tube equivalent to the stroke length. Cushions not avilable on spring end of cylinder. Standard spring forces for SR and SC = 3.5 lbs relaxed, 11.5 lbs compressed Notes: Available on 1-1/8" bore cylinders only. 1/4" effective cushion length. Add 9/16" to overall length of cylinder for each cushion. Cushion not available on spring end of a single acting cylinder. VT SR - 3/8 - 1.125 x 5.000 - RC - PS Series ET, T & VT Tiny Tim