Datasheets

54D_Pressure_Sensor_Datasheet

Norgren Featured Datasheets

Issue link: https://onenorgren.uberflip.com/i/1471218

Contents of this Issue

Navigation

Page 2 of 2

Our policy is one of continued research and development. We therefore reserve the right to amend, without notice, the specifications given in this document. (2019 - 9261a) © 2015 IMI International s.r.o. en 5.11.486.03 06/22 .51 (13) 1.45 (36.9) 1.18 (30) 1 2 1.38 (35) 1.65 (42) .19 (4.75) .79 (20) ø.17 (4.2) 1.26 (32) 1.26 (32) 1.18 (30) .44 (11.3) .81 (20.7) Dimensions in inches (mm) Projection/First angle Dimensions pressure switch Dimensions accessories DIN-Railclip 54D-DINRAIL-CLIP 1 Mounting screws (Stainless steel, 1.4310/301) 2x M4 x 35 2x M4 x 40 1 Main pressure connection (G1/8) 2 Auxiliary pressure connection for differential pressure sensing (M5) These products are intended for use in industrial compressed air systems only. Do not use these products where pressures and temperatures can exceed those listed under »Technical features/data«. Before using these products with fluids other than those specified, for non-industrial applications, life-support systems or other applications not within published specifications, consult IMI Precision Engineering. Through misuse, age, or malfunction, components used in fluid power systems can fail in various modes. The system designer is warned to consider the failure modes of all component parts used in fluid power systems and to provide adequate safeguards to prevent personal injury or damage to equipment in the event of such failure. System designers must provide a warning to end users in the system instructional manual if protection against a failure mode cannot be adequately provided. System designers and end users are cautioned to review specific warnings found in instruction sheets packed and shipped with these products. Warning

Articles in this issue

Archives of this issue

view archives of Datasheets - 54D_Pressure_Sensor_Datasheet