Datasheets

01/22 Factory Automation > Compact pneumatic power amplifiers > Sense very low pneumatic signals > Provide on/off control of a high pressure air supply > Low and ultra-low pressure models > Inputs (control) from pneumatic sensors, logic devices, in rumentation sy ems > Provide direct operation of small actuators (cylinders), large air piloted valves, and other small pneumatic devices Technical features Medium: Filtered (25μ), lubricated or nonlubricated compressed air Max. Control Pressure: 5 psig (.3 bar) Inlet Pressure: Minimum: 20 psig (1.4 bar) Maximum: 125 psig (8.6 bar) Temperature Range: 35° to 150°F (2° to 66°C) Equivalent Orifice Size: 0.094" (2.4 mm) Cycle Rate: 900 cpm Ports: Control: 10-32 UNF Main: 1/8 PTF Materials of Construction: Body: Aluminum Piston Assembly: Aluminum, Acetal End Caps: Polycarbonate, Nylon Springs: Stainless steel Elastomers: Buna-N Boo ermites Our policy is one of continued research and development. We therefore reserve the right to amend, without notice, the specifications given in this document. © 2022 Norgren Ltd Service Kit Part Number (includes seals): P0150A-01 Operation: Boostermites are bleed actuated, 2-position, 3-way, 3-port, normally closed poppet valves. Supply pressure travels through an orifice and is vented to atmosphere. When a control signal is applied, it energizes a diaphragm, compressing a spring and cutting off the vent passage. Pressure is now directed from the supply to the poppet piston, which shis the valve, connecting the inlet to the outlet ports. When the control signal is removed, the spring returns the diaphragm to its non-energized position, and the supply signal is once again vented to atmosphere, and the poppet piston shis the valve to the non-actuated position. 1/8-27 PTF 3 Places 2.09 (53) 1.33 (34) 10-32 UNF .19 (5) 2 Places .88 (22.4) 5BV-011-10A 10-32 UNF 1/8 PTF 5BV-010-10A 10-32 UNF 1/8 PTF 3" H2O (7.5 mbar) 1/2" H2O (1.3 mbar) 10" H2O (25 mbar) 5" H2O (12.5 mbar) Pneumatic Port Port Thread Main Symbol Number Control Positive ON/OFF Actuation Points ON when control signal is more than:* OFF when control signal is less than:* IN EX OUT Control * Variation with attitude change: 1/2" H2O (1.3 mbar) Furnished with two 1/2" long mounting spacers and a control port adapter for use with 1/16" ID flexible tubing. Warning These products are intended for use in industrial compressed air systems only. Do not use these products where pressures and temperatures can exceed those listed under »Technical features/data«. Before using these products with fluids other than those specified, for non-industrial applications, life-support systems or other applications not within published specifications, consult IMI Precision Engineering, Norgren Ltd. Through misuse, age, or malfunction, components used in fluid power systems can fail in various modes. The system designer is warned to consider the failure modes of all component parts used in fluid power systems and to provide adequate safeguards to prevent personal injury or damage to equipment in the event of such failure. System designers must provide a warning to end users in the system instructional manual if protection against a failure mode cannot be adequately provided. System designers and end users are cautioned to review specific warnings found in instruction sheets packed and shipped with these products.

• Cover