Step 1
Step 4
Step 3 Step 2
Align bushing
with drive pin
Remove
M5 screw
Remove
side plate
Push sensor in
direction of arrow
M5 X 16mm
screw
M5 X 16mm
screw
Step 3 Step 4
Push sensor in
direction of arrow
Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document. © 2020 Norgren Automation Solutions, LLC
00550UI REV: 002
160272.02
10/20
3. Installation:
3.1. (Step 1) Take off the side plate from the side of the gripper which the sensor is to be mounted to by
removing the 5mm screw.
(Step 2) Align the brass bushing in sensor to the drive pin in the gripper.
(Step 3) Keeping the sensor parallel to the side of the gripper, move the sensor close enough so that
the dowel pins align with the slots in the frame. From that point the sensor is pushed farther onto
the gripper with a motion indicated in the Step 3 figure.
(Step 4) Clean and apply Loctite 262 or equivalent to supplied screw (M5 X 1.0 X 16mm SHCS).
Insert screw through sensor and tighten to 72in-lb.
