22
GC3 Gripper
220
221
6
200
201
406
Replacing the cylinder:
1. Loosen the four orbital mount set screws #406.
2. Remove four (4) long socket head cap screws #220 or
#221 depending on mount options.
3. Pull gripper head and cylinder #200 or #201 apart with
your hands until the rod end #6 is exposed.
4. Being careful not to mar the surface, secure the rod
end which is now visible and unthread the cylinder from
the rod end.
Changing the Cylinder
Lubricating Instructions:
1. Use MOBILITH SHC 1500 Grease.
2. Coat both sides of the middle section of the base #1.
3. Coat inner side and slot of side plates #2.
4. Coat lower half (both sides) inner surface of slot and pivot
hole of arms #3, #4, or #5, depending on head type.
5. Coat all sides of guide blocks, #8.
6. Coat I.D. and O.D. of rollers, #10.
7. Coat length of dowel pin, #11.
2
8
8
11
1
2
3
10
10
4 5
3 4 5
Lubricating the GC Gripper
