Issue link: https://onenorgren.uberflip.com/i/1241448
16 V E R SA TO O L I N G 1 For more information or for additional configurations, please contact us at NASInsideSales@imi-precision.com » The Series LRR20 Rail Receiver and LRA20 Receiver Adapter use steel locating pins to reduce rotational finger movement. » This keeps tooling movement at the end of a 12 inch offset to less than +.022 inches without the use of a locking handle. » The finger assembly snaps into the receiver and is held in place by a spring loaded latch. » Li the latch and the finger slides out of the receiver. » An optional locking handle is provided for use on fingers with extreme offsets or with rotators and linear slides that generate unusual rotational forces. Steel locating pins for precise repeatability Spring-loaded release latch Note 1: Weight comparison based on a typical 20 inch long transfer finger configured as shown in cover photo. Note 2: Dynamic load capacities shown above will provide a tooling life of 5 million cycles at 1G acceleration rates that are typical of transfers running 20 SPM. Note 3: A bolt torque of 15 . lbs. is the typical torque achieved by a person hand tightening a bolt using a standard Allen wrench. Note 4: The Micro Versa‑Link system was designed for use on short fingers and low clearance applications. All current components are designed for the fabrication of shovel fingers only. Gripper fingers are not currently supported. The typical weight specification shown is for a 15 inch long finger. Typical Finger Weight note 1 Load Capacity note 2 Unique design and performance characteristics with shovel with gripper static dynamic Versa‑Link ball to ball system 4.2 lbs. (1905.1gr) 5.6 lbs. (2540.18gr) 250 . lbs. @15 . lbs. bolt torque note 3 100 . lbs. @15 . lbs. bolt torque note 3 Ball to ball clamp cannot be installed incorrectly. High load capacity achieved at low bolt torque levels. Simplified system 4.4 lbs. (1995.8gr) 6.11 lbs. (2771.5gr) 150 . lbs. @28 . lbs. bolt torque 50 . lbs. @28 . lbs. bolt torque Simple right‑angle finger designs. Micro Versa ‑ Link ball to ball system with Shovel note 4 2.8 lbs. (1270.1gr) 120 . lbs. @12 . lbs. bolt torque 50 . lbs. @12 . lbs. bolt torque Similar to Versa‑Link ball to ball system. Reduced size simplifies finger design in low clearance applications. MODULAR TOOLING DECISION GUIDE