Jaw Angle
Z Angular
PGS10 Z 77 NUL NUL E
Jaw Angle
20 22° x 0°
21 22° x 11°
22 22° x 22°
40 45° x 0°
42 45° x 22°
44 45° x 45°
70 70° x 0°
73 70° x 35°
77 70° x 70°
Port Orientation
E Top 1/8" NPS
F Top 1/8" Rc
L Right 1/8" NPS
M Right 1/8" Rc
S Bottom 1/8" NPS
T Bottom 1/8" Rc
Z Left 1/8" NPS
2 Left 1/8" Rc
No Sensor
No Pad
Body Style
10
Standard 1.20"x1.20"
bolt pattern
11
Crossover 0.90"x0.90"
bolt pattern
The model number for z line jaw gripper consists of an
alphanumeric cluster designating the jaw type and angle, and
the port orientation.
An example of an angular jaw gripper with a standard body
style, angular jaw at 70° x 70° angle, with a port orientation
of a top 1/8" NPS is shown below. See details below:
Ordering Information
PGS Angular Gripper - Port Orientation
How To
35 35
35
How To Specify
35
The gap between the grip points when the jaws are parallel is Gap =
Material Thickness - *0.5mm
*0.5mm is used as a correction factor for fits and tolerances
*// indicates the 2 surfaces are parallel
Example - For material thickness of 2mm, Gap is 2mm - 0.5mm=1.5mm
A= 40.7mm-1.5mm = 19.6mm
2
In order to achiev rated MCBD of million cycles, it is
recommended that moment of inertia along Izz be less than -
For fully open jaws, Izz < 0.588 lbs.in
2
For 45 opening, Izz < 0.882 lbs.in
2
For 22 opening, Izz < 1.176 lbs.in
2
This includes mounting hardware, pads and jaw extension.
