Issue link: https://onenorgren.uberflip.com/i/541253
Our policy is one of continued research and development. We therefore reserve the right to amend, without notice, the specifications given in this document. (2015 - 5018b) © 2015 Fluid Automation Systems s.a. FAS 10 mm PICOSOL MS Media separated solenoid valve en 5.2.032.02 3/15 Dimensions shown in mm Projection/First angle Dimensions 1 Manifold Model: On request (PEEK) 1 Sealing area 2 The recommended mounting screw tightening torque is 0,15 + 0,1 Nm. All solenoids are supplied with mounting screws and gasket. 1 Threads for mounting screws - M2 x 5 mm deep Warning 6,4 2,54 2 10 28 24 2 7,6 11,6 37 8 4 17 6,2 4,6 M2 2 22,5 4,2 3 2 1 1 6,2 ±0,05 M5 1 10 8 ±0,5 3 3 20 M5 3 3 28 24 ±0,05 These products are intended for use in neutral or aggressive gases and liquids only. Do not use these products where pressures and temperatures can exceed those listed under »Technical features«. Before using these products with fluids other than those specified, for non-industrial applications, life-support systems, or other applications not within published specifications, consult FAS. Through misuse, age, or malfunction, components used in fluid power systems can fail in various modes. The system designer is warned to consider the failure modes of all component parts used in fluid power systems and to provide adequate safeguards to prevent personal injury or damage to equipment in the event of such failure. System designers must provide a warning to end users in the system instructional manual if protection against a failure mode cannot be adequately provided. Electrical connector Model: S110.1032 15 5 5,5 2,54